I would appreciate any donations. Wishlist or send e-mail type donations to maekawa AT daemon-systems.org.

Thank you.

FPA(4)                       Device Drivers Manual                      FPA(4)

     fpa, fea, fta - DEC FDDI interface driver

     fpa* at pci? dev ? function ?
     fea* at eisa? slot ?

   alpha and pmax
     fta* at tc? slot ? offset ?

     Cards supported by the fpa, fea and fta device driver are:

           DEFPA   DEC PCI FDDI Controller

           DEFEA   DEC EISA FDDI Controller

           DEFTA   DEC TURBOchannel FDDI Controller

     respectively.  All variants of either controller are supported including
     the DAS and SAS configurations.

     fea%d: error: desired IRQ of %d does not match device's actual IRQ
     (%d)  The device probe detected that the DEFEA board is configured for a
     different interrupt than the one specified in the kernel configuration

     fea%d: error: memory not enabled! ECU reconfiguration required  The
     device probe found that no device memory had been configured on the
     DEFEA.  The DEFEA can be configured with no device memory, this driver
     requires a minimum of 1K device memory be set up.  The ECU (EISA
     Configuration Utility) will need to be run to change the settings.

     arp(4), netintro(4), ifconfig(8)

     The fpa, fea and fta device driver and manual page were written by Matt

     Normally, the device driver will not enable the reception of SMT frames.
     However if the IFF_LINK1 flag is set, the device driver will enable the
     reception of SMT frames and pass them up to the Berkeley Packet Filter
     for processing.

NetBSD 8.99.34                  March 13, 1995                  NetBSD 8.99.34